The Pioneer TS-W307D2 offers you a variety of set-up possibilities, provided that there is correct power matching between the subwoofer and your amplifier. So, whether you are building your system from an existing stereo or mono amp, or whether you want a basic set-up with expandability potential, the Pioneer TSW-307D2 will cover common impedance loads . Pioneer TS-W307D2 uses IMPP (Injection Molded Polypropylene) cone is constructed from a composite blend of interlaced Aramid fibres, which make this Pioneer TSW-307D2 extremely rigid; yet lightweight, for low distortion and powerful bass at high sound press levels. The speaker terminals have been placed on one side of the TSW-307D2 subwoofer, rather than on both sides as with conventional subs; this gives you greater installation flexibility. Pioneer TS-W307D2 subwoofer features: - 12" 1200W subwoofer
- Dual Voice Coil
- Watts MAX. Music Power: 1200 Watts
- Watts Nominal Power Handling: 400 Watts
- Frequency Response : 18 ~ 500Hz
- Sensitivity: 89dB
- Dual 2ohms voice coil: (sub can be wired into 1 or 4 ohm )
- Dimensions 327 mm x 172 mm
- Mounting Depth 153 mm
- Composite IMPP Cone using Interlaced Aramid Fiber
- Cone Reinforcement Arcs
- Wide Roll, Three-Layer Fiber Woven Radial Surround
- 4-Layer, Copper Long Voice Coil
- Conex Spider
- Projected Pole Yoke with Vented Pole
- Magnet Construction: Double Mass High-Power (83oz)
- Basket Design: Stamped Basket with Magnet Cover
- Gasket: Molded
- Wire Terminals: Integrated Single-Sided Silver Compression Terminals
In-Phase IPA500 amplifier features: - 500W 2 channel amplifier
- MOSFET power supply
- High level input (speaker level input)
- Variable gain adjustment
- Build in crossover
- Build in high pass / low pass filter
- Thermal protection
- Overload protection
- High brightness blue LED
This Package Contains: - Pioneer TS-W307D2 subwoofer
- In-Phase IPA500 amplifier
- Juice JW1000 wiring kit
- Single 12" Bass Box
| Customers who bought this product also purchased |
|
