The Pioneer TS-W307D2 offers you a variety of set-up possibilities, provided that there is correct power matching between the subwoofer and your amplifier. So, whether you are building your system from an existing stereo or mono amp, or whether you want a basic set-up with expandability potential, the Pioneer TSW-307D2 will cover common impedance loads . Pioneer TS-W307D2 uses IMPP (Injection Moulded Polypropylene) cone is constructed from a composite blend of interlaced Aramid fibres, which make this Pioneer TSW-307D2 extremely rigid; yet lightweight, for low distortion and powerful bass at high sound press levels. The speaker terminals have been placed on one side of the TSW-307D2 subwoofer, rather than on both sides as with conventional subs; this gives you greater installation flexibility. Pioneer TS-W307D2 subwoofer features: - 12" 1200W subwoofer
- Dual Voice Coil
- Watts MAX. Music Power: 1200 Watts
- Watts Nominal Power Handling: 400 Watts
- Frequency Response : 18 ~ 500Hz
- Sensitivity: 89dB
- Dual 2ohms voice coil: (sub can be wired into 1 or 4 ohm )
- Dimensions 327 mm x 172 mm
- Mounting Depth 153 mm
- Composite IMPP Cone using Interlaced Aramid Fiber
- Cone Reinforcement Arcs
- Wide Roll, Three-Layer Fiber Woven Radial Suround
- 4-Layer, Copper Long Voice Coil
- Conex Spider
- Projected Pole Yoke with Vented Pole
- Magnet Construction: Double Mass High-Power (83oz)
- Basket Design: Stamped Basket with Magnet Cover
- Gasket: Molded
- Wire Terminals: Integrated Single-Sided Silver Compression Terminals
Kenwood KAC-5203 amplifier features: - 350 Watts max power (4 ohms bridged)
- Aluminium die-cast heat sink
- 2 ohm load capability
- Power MOSFET switching power supply
- Complete with full fitting and operating guide
This Pack Contains: - Pioneer TS-W307D2 Subwoofer
- Kewnood KAC-5203 amplifer
- Juice JW1000 1000 watts wiring kit
- 12" Bass Box
|
